Home > Exhibition > Content
Metric rod end bearing operation technology and heating temperature
Jul 04, 2018

Where the metric rod end bearing can not use the press, it can be assembled with the casing and the hammer mounted end rod joint bearing during the operation, and the hammering force should be evenly distributed on the entire circumference of the ferrule end surface of the end rod joint bearing. Therefore, the end face of the assembled casing that is hammered should be made spherical.

  

The metric rod end bearing is required to be installed to some extent with the force required for the end rod joint bearing and the size of the joint bearing and the amount of interference. In the process of operation, it is effective for medium or large-sized medium with large interference. Joint bearings are commonly used in hot charging methods. Before hot loading, put the end rod joint bearing or the separable joint bearing ring into the fuel tank or special heater and heat it evenly to 80-100 °C.

  

The metric rod end bearing needs its skilled operation technique during operation. When the joint bearing is taken out from the heating tank or the heater during use, the oil track on the surface of the joint bearing should be wiped off with a clean cloth immediately. And the attachment, then placed in front of the mating surface, pushing the joint bearing to the shoulder against the shoulder in one operation.


http://www.wxjwbearing.com

Products List